Health, Safety and Welfare for Construction and the Built Environment Essay - 1

Health, Safety and Welfargon for Construction and the Built Environment - Assignment 2 - Essay ExampleWe in addition use data for the department of labour to ascertain if certain types of identified risks are preventable as well as their chances of recurrence.When we beat compiled the information to the highest degree probable chances of hazards at the construction site, a decision is made based on this particular information. We also analyse the statistics of similar hazards identified or that have occurred in other construction sites in order to come up with effective solutions to prevent them. The diagram below illustrates the methods we use to identify potential hazards at out construction site.The most common hazards in any construction site include slips, trips and falls. These may cause both minor and severe injuries. Slips are common on wet surfaces while falls and trips can occur at any stage of construction.Lifting crane is a commonly used for lifting build material lik e bricks, cement, sand and other material. However, there is a risk that the items may fall which can cause injuries among the employees.Answer Standard formats for identifying and record hazards on site are mainly used for presenting a solid basis upon which all hazards can be measured, interpreted as well as addressed. Our phoner has its own regulation form of identifying and recording hazards.We mainly use this standard form to get feedback from the employees and supervisors. It provides all possible and probable hazards so safety supervisors do not pack to think a lot during questioning. He just needs to follow the standard form.Another very important use of the standard form is to compile data. If we dont have any standard form to identify hazard, collected data will be a mess. conclusion out data from that mess will be very hard. By using the standard form, we can compile the data as our requirement. We just need to set the standard form in the desired format.By using stan dard form to identify and record hazards, we actually make this data